A variable throw eccentric cone crusher. The cone crusher comprises a frame, a crusher head supported on the frame for gyration about a first axis, a bowl supported on the frame in spaced relation to the crusher head, and a mechanism on the frame for varying the eccentricity of the gyration of the crusher head. An eccentric member engages the crusher head and is eccentrically pivotable about a ...
5.1. The throw of the crusher is the distance that moving jaw moves in going from OSS to CSS. Throw = OSS-CSS. The capacity is a function of size and OSS. Manufacturers publish tables of capacity for their crushers of various size as a function of the open-side set. 5.1.1 Cone crushers
Cone crushers are often placed within the secondary crushing station because they are versatile in terms of feed, closed side setting, speed, and throw. With cone crushers, though, it is essential to operate them at consistent choked settings to keep productivity up. 3. Tertiary/Quaternary/Final Reduction Crushing
HP800 Cone Crusher. Stationary : One HP500, one HP300, two HP200 crushing Amphibolite . Higher yield By operating the HP cone crusher on the lower end of its speed range, the product gradation can be shifted to produce fewer fines and a higher percentage of on-spec product. The HP cone crusher creates a higher value product with less waste.
The throw of the cone crusher is the difference of the maximum distance between the bowl liner and the mantle (the open side setting) and the minimum distance between the bowl liner and the mantle (the closed side setting). Typically, the throw of a cone crusher is set by the degree of eccentricity of the eccentric member which transforms the ...
Jan 17, 2016 At this level Throw = OSS – CSS A crusher that has a 20cm throw is one where the mantle surface approaches and recedes from the concave through a distance of 20cm as measured at the level of the choke point. Another factor which governs the proportions of the crushing chamber is the maximum permissible angle between the two crushing faces. This also is subject to a …
• In a cone crusher the stones are crushed with both SPB and IPB as the material moves down through the chamber. • The relative amounts of IPB and SPB depends on factors like chamber design, crusher geometry, speed, css, eccentric throw, and others. SPB
Cone Crushers. A Cone Crusher is a compression type of machine that reduces material by squeezing or compressing the feed material between a moving piece of steel and a stationary piece of steel. Final sizing and reduction is determined by the closed side setting or the gap between the two crushing members at the lowest point.
Feb 17, 2016 Gyratory Crushers. The primary rock breaker most commonly used in large plants is the gyratory crusher, of which a typical section is shown in Fig. 5. It consists essentially of a gyrating crushing head (521) working inside a crushing bowl (522) which is fixed to the frame (501).
LATEST NEWS
OUR LATEST NEWS